Shift boot removal and installation.
Dodge Stealth and Mitsubishi 3000gt instructions.
Print this page to make it easier for you.

Remove the knob at the top of the shifter by turning it counter clockwise.

Pull the old boot upwards to disengage the frame from the console. Continue pulling the boot up over the top of the shifter shaft.

Make note of the boot position on the shifter before removing it.

Cut the zip tie that holds the old boot in place on the shifter.

Remove the old boot from the frame that holds it to the console.

To replace the new boot simply reverse the above procedure.

Put the new boot on the frame.

Push the boot down through the frame so it is inside out and place it over the shift knob.

Pull it down to the same place that you marked as being the original position.

Place the zip tie around the leather boot and pull tight to lock it in place.

Push the boot and frame down over the shifter and push the frame back into the console.

This will complete the shift boot removal and installation.

Emergency brake boot replacement.

Reach between the seat and the center console. Pull up on the old boot rolling it up the brake lever, 

while turning it inside out. Cut the zip tie at the top. Finish removal.

Turn the new boot inside out. Place it on the lever. Place the zip tie on and pull tight. Roll the new 

boot over the shaft turning it right side out. Tuck it back between the seat and the console.